TOPIC: WY-99GT  and  ALLOY off a "PC SLAVE" card.

DATE:  06/09/90

PRODUCT:        WY-99GT

THE ISSUE:
   How to configure the WY-99GT to support Alloy off a "PC SLAVE" card

OVERVIEW:
   "PC-SLAVE" card Configuration:
   Set up according to the your specifications.  But I tested with
   the card addressing the first address.

                1    2    3    4    5    6    7    8
        SB2 - | dn | dn | dn | dn | dn | dn | dn | up
        SB3 - | dn | up | up | up | up | dn | up | up

        The cable configurations must be as follows:

        DB25 Connector                    DB9 Connector
             1 ------------------------------ 1
             2 ------------------------------ 2
             3 ------------------------------ 3
             4 ---
             5 ---|
             6 ------------------------------ 5
             8 ---|
             20---|
             7 ------------------------------ 7

   Now go into NXCNFG file provided by Alloy and setup the type of
   terminal, baud rate, data and stop bits, handshake, etc.

RESOLUTIONS:
        I used the following configurations:

                Terminal Type       WY99/G or PCST/G
                Baud Rate           38400
                Data bits           8
                Stop bits           1
                Parity              none
                DOS version         3.10 or 3.20

        The terminal configurations:
                Personality             PC Graphics
                Baud Rate                       38400
                Data bits                       8
                Stop bits                       1
                Parity                  none
                RCV Handshake           DTR
                XMT Handshake           none
                XPC Handshake           ON

        ****** NOTE ******
   The latest version of Alloy software has provided a WY-99GT driver
   so that it is written specifically for the WY-99GT.  With the
   preceding setup, I was able to run all major software with no
   problems.  This was also confirmed with Alloy Computer Products
   in Framingham, MA.  Remember that all applications must be
   configured for the Hercules graphics.

   This was tested with an 8 MHz unit (WY-2108).  I had it set for 
   512K,  640K, and 1Meg of system memory.

=-=-=-=-=-=-=-=-=-=-=-=-=   DISCLAIMER   =-=-=-=-=-=-=-=-=-=-=-=-=-=-=
  This information is intended to inform WYSE personnel and WYSE
  customers of certain issues in a timely fashion. The information
  has not been extensively verified or tested. WYSE does not warrant
  the information to be correct, although reasonable effort has been
  taken to prevent gross inaccuracies. WYSE publishes formal technical
  communiques in the form of Product Bulletins and warrants the data
  in Product Bulletins to be accurate at the time of the release.