TOPIC:  CODES to change personalities in VT100/220 AND TEK4010/4014

DATE:   07/05/89

PRODUCT:        WY-99GT

THE ISSUE:
        CONFINED TO:    FIRMWARE D0.1
        The following are the WY99GT emulation change commands.

RESOLUTION:
                        CTRL[ = ESC
        ________________________________________________________
        FROM          COMMAND SEQ.                       TO
        --------------------------------------------------------

        VT220/7        CTRL[[61"p                        VT100
        VT100          CTRL[[62;1p                       VT220/7
        VT220/7        CTRL[[?38h                       TEK4010/4014
        TEK4010/4014   CTRL[[?381                        VT220/7
        VT100          CTRL[[?38h                       TEK4010/4014
        TEK4010/4014   CTRL[[?381                        VT100
                       CTRL[[61"p
        TEK4010/4014   CTRL[[42h                         99GT
                       CTRL[[?381
        VT220/7        CTRL[[42h                         99GT
        TEK4010/4014   CTRL[[42h                         WY50
                       CTRL[~"
        VT220/7        CTRL[[?21                         VT52
        TEK4010/4014   CTRL[[42h                         VT220/8
                       CTRL[~=
        TVI910+        CTRL[~<                           VT220/7
        VT220/7        CTRL[[42h                         TVI910+
                       CTRL[~#
        TEK4010/4014   CTRL[[?381                        VT220/8
                       CTRL[[62;2p

   *** All command sequences in TEK4010/4014 mode must be executed in
       block mode (BLK) or be down loaded from the operating system.

=-=-=-=-=-=-=-=-=-=-=-=-=   DISCLAIMER   =-=-=-=-=-=-=-=-=-=-=-=-=-=-=
  This information is intended to inform WYSE personnel and WYSE
  customers of certain issues in a timely fashion. The information
  has not been extensively verified or tested. WYSE does not warrant
  the information to be correct, although reasonable effort has been
  taken to prevent gross inaccuracies. WYSE publishes formal technical
  communiques in the form of Product Bulletins and warrants the data
  in Product Bulletins to be accurate at the time of the release.