TOPIC:      WYSE 99GT TERMINAL RESET INSTRUCTIONS

DATE:       OCTOBER 18,1991

THE ISSUE:
        WY 99GT  RESET PROCEDURES

RESOLUTION:
                     WYSE 99GT TERMINAL RESET INSTRUCTIONS

 ***   The following procedure will reset all setup parameters back to the
 ***   factory default.   PLEASE  take note of them before performing
 ***   the following steps.

      1. Power off terminal and disconnect all cables except for power.

      2. Power up terminal holding the letter g depressed. Hold this key
         down until you pass self tests.

      3. Go into setup, select default all, save and exit setup menu.

      4. You can now go back into setup and configure your terminal to your
         required settings.


=-=-=-=-=-=-=-=-=-=-=-=-=   DISCLAIMER   =-=-=-=-=-=-=-=-=-=-=-=-=-=-=
  This information is intended to inform WYSE personnel and WYSE
  customers of certain issues in a timely fashion. The information
  has not been extensively verified or tested. WYSE does not warrant
  the information to be correct, although reasonable effort has been
  taken to prevent gross inaccuracies. WYSE publishes formal technical
  communiques in the form of Product Bulletins and warrants the data
  in Product Bulletins to be accurate at the time of the release.