Firmware Identification Procedure

                                  WY60

                      Modem Port  -  Female Connector

 1. Jumper pins 2 & 3 on the Modem Port, these are the second and third pins
    from the upper right hand corner as you look directly at the port from
    the back of the terminal.
                                             _
                       13                   | |  1
                      _____________________ | | ____
                      \ o o o o o o o o o o o o o  /
                       \ o o o o o o o o o o o o  /
                        \_______________________ /
                         25                    14

 2- Enter the Setup mode, press SHIFT SETUP, SHIFT SELECT or SHIFT SYS REQ
    depending on your keyboard type, and change the following parameters:

      A.  Under F1 STATUS LINE = STANDARD

      B.  Under F2 PERSONALITY = WY 60 (native mode)

      C.    "   "  COMM MODE = FULL DUPLEX

    Exit SETUP by striking F10 two times.

 3- Caps lock must be turned off.

 4- Depress the ESC key (or control [ at the same time if you are using the
    ANSI style keyboard).

 5- Depress the d key

 6- Turn on the caps lock, CAPS should display on the status line

 7- Depress a shift and " at the same time (" is near the enter key)


 You should see an alpha-numeric string display on your screen that will
 include the firmware revision number, date, and abbreviated WYSE Technology.

 For Example:      RBNFC2 1987 WYSE TECHNOLO

 C2 is the firmware revision, Copyright 1987, etc.

 C3 is the appropriate firmware for a WY60 with a parallel auxiliary port.




=-=-=-=-=-=-=-=-=-=-=-=-=   DISCLAIMER   =-=-=-=-=-=-=-=-=-=-=-=-=-=-=
  This information is intended to inform WYSE personnel and WYSE
  customers of certain issues in a timely fashion. The information
  has not been extensively verified or tested. WYSE does not warrant
  the information to be correct, although reasonable effort has been
  taken to prevent gross inaccuracies. WYSE publishes formal technical
  communiques in the form of Product Bulletins and warrants the data
  in Product Bulletins to be accurate at the time of the release.